Omega DPF78 User Manual

2

The unit is designed to be mounted with a gasket providing a water tight seal.  Two mounting brackets are provided to
secure the unit to the panel.  A panel less than .1" may distort if the clamps are screwed too tightly.

Slide the body of the unit through the rubber gasket.  Insert the unit into the panel.  As shown in "FIG. A", slide the brackets
up the groove to press against the back of the panel.  Insert screws into rear of brackets and tighten them evenly and
alternately.  Do not over tighten!  A normal level of torque is required.  Maximum torque should be 3" pounds.

This product is designed to be panel mounted and is NEMA 4 rated if proper mounting procedures are followed and the
required and supplied hardware is correctly used.

If the panel in which the unit is mounted is less than .125 of an inch thick, the possibility exists that there will be some
flexing.  Should this flexing occur, the resulting deformation of the panel could cause a loss of the water tight seal.  In case
this should occur, the use of silicone or other sealant would be recommended.

This product is designed to the NEMA 4 rated.  However, the fact that we are unable to control either the location in which
the device is installed or the actual installation itself requires that the company's liability shall extend only to the repair or
replacement of a defective product.

We are prepared to offer additional assistance in those special situations where normal mounting methods do not seem to
satisfy the customers needs.  This assistance may be obtained by calling the factory and asking for Application Engineer-
ing.

3.622

(92)

1.772

(45)

4.437

(112.7)

2.625

(66.68)

0.587

(14.91)

4.245

(107.8)

BEZEL

GASKET

CUSTOMER PANEL
Panel Thickness 0.062" (1.5)
to 0.187" (4.7) max.

3.925

(99.7)