Samsung M-ER290 User Manual
56 • Advanced Programming Instructions ER-290 Electronic Cash Register
%1 and %2 Key Programming
There are two percentage keys on the keyboard: %1 and %2. The %1 key applies a surcharge.
The %2 key applies a discount. Without any further programming, you can apply a discount or
surcharge to an individual item or to the subtotal of a sale by entering a percentage and pressing
the %1 or %2 key. This program allows you to:
The %2 key applies a discount. Without any further programming, you can apply a discount or
surcharge to an individual item or to the subtotal of a sale by entering a percentage and pressing
the %1 or %2 key. This program allows you to:
z
decide to calculate any taxes before or after the percentage is applied
z
set a preset percentage for the %1 or %2 key
z
if a preset percentage is set, decide if you wish to also allow a percentage to be entered
z
inactivate the key
Programming the %1 or %2 Key
1. Turn the control lock to the PGM position.
2. Enter the percentage rate you wish to preset, or 0 if you only wish to enter the
percentage. Press the %1 or %2key, depending on which key you are programming.
Be sure to enter the decimal point if you are setting a rate that is not an even
percentage, i.e. enter 33
Be sure to enter the decimal point if you are setting a rate that is not an even
percentage, i.e. enter 33
1
/
3
% as 3 3 . 3 3 3. If you are setting an even percentage, it is
not necessary to enter the decimal point, i.e. enter 50 % as 5 0.
3. To decide if tax is calculated before or after the percentage is applied, complete the
table below by adding the status digits for each tax. Then enter the resulting tax status
code.
code.
Calculate Rate 1 after the
discount/surcharge?
discount/surcharge?
Yes = 1
No = 0
+
Calculate Rate 2 after the
discount/surcharge?
discount/surcharge?
Yes = 2
No = 0
+
Calculate Rate 3 after the
discount/surcharge?
discount/surcharge?
Yes = 4
No = 0
+
Calculate Rate 4 after the
discount/surcharge?
discount/surcharge?
Yes = 8
No = 0
+
=
4. Enter:
0
If you wish to allow the operator to also enter a percentage (override).
1
If you do not wish to allow the operator to also enter a percentage
(override).
(override).
2
If you wish the key to be inactive.
5. Enter:
0
-% (default)
1
+%
6. Press the CASH/TEND key to end programming.