Acu-Rite CNC 3500i User Manual
76
4 Tool Management
4.2 T
ool D
a
ta
Contouring with radius compensation
The tool center moves along the contour at a distance equal to the
radius. “Right” or “left” are to be understood as based on the
direction of tool movement along the work piece contour as viewed
from behind a moving tool.
radius. “Right” or “left” are to be understood as based on the
direction of tool movement along the work piece contour as viewed
from behind a moving tool.
Between two program blocks with different radius
compensations, you must program at least one traversing
block in the working plane without radius compensation
(G40).
compensations, you must program at least one traversing
block in the working plane without radius compensation
(G40).
The CNC does not put radius compensation into effect
until the end of the block in which it is first programmed.
until the end of the block in which it is first programmed.
In the first block in which radius compensation is activated
with, or canceled, the CNC always positions the tool
perpendicular to the programmed starting or end position.
Position the tool at a sufficient distance from the first or
last contour point to prevent the possibility of damaging
the contour.
with, or canceled, the CNC always positions the tool
perpendicular to the programmed starting or end position.
Position the tool at a sufficient distance from the first or
last contour point to prevent the possibility of damaging
the contour.