Acu-Rite CNC 3500i User Manual
ACU-RITE 3500i
171
7.
2
C
a
n
n
e
d
C
y
c
le
s
Continued:
G-code format: G73
Draft Angle Pocket Example:
This program cuts the draft angle pocket shown in the figure. The
drawing does not show the finish pass. Assume an existing
rectangular pocket (4 in. long x 2 in. wide x 1 in. deep) with a
theoretical sharp lower-left corner at X2 Y2. The following program
machines a draft angle onto the existing pocket.
drawing does not show the finish pass. Assume an existing
rectangular pocket (4 in. long x 2 in. wide x 1 in. deep) with a
theoretical sharp lower-left corner at X2 Y2. The following program
machines a draft angle onto the existing pocket.
The tool performs the following operations:
Position the tool above the center of the lower-left corner radius.
The tool path starts and ends at the center of the lower-left corner
radius (after each perimeter pass) for all roughing passes. During
finish passes, the tool steps down the draft angle and makes passes
around the perimeter.
The tool path starts and ends at the center of the lower-left corner
radius (after each perimeter pass) for all roughing passes. During
finish passes, the tool steps down the draft angle and makes passes
around the perimeter.
If a ball-end mill is programmed (W), the following points must be
considered: the length (X) and width (Y) at the bottom of the pocket
is measured at the tangency point of the ball radius, and the draft
angle. The start height (H) must be set to (0.1 + ball radius) above
surface to be cut. Set the tool-length offset so that the ball is buried
up to its centerline when at the part surface (touch off the tip and
add the ball radius, or touch off tip and use a negative length wear
equal to the ball radius).
considered: the length (X) and width (Y) at the bottom of the pocket
is measured at the tangency point of the ball radius, and the draft
angle. The start height (H) must be set to (0.1 + ball radius) above
surface to be cut. Set the tool-length offset so that the ball is buried
up to its centerline when at the part surface (touch off the tip and
add the ball radius, or touch off tip and use a negative length wear
equal to the ball radius).
Field
Code
Description
Max XY
Step
Step
V
Maximum XY tool stepover. Used if angle is
so great that the amount of XY step per Z
step exceeds 70 % of the tool diameter.
so great that the amount of XY step per Z
step exceeds 70 % of the tool diameter.
Z Step
Finish
Finish
Q
Z-axis finishing step-down.
Finish STK
XY
XY
S
XY finish stock amount, sides only.
Finish
Feed
Feed
K
Finish-pass feedrate.
Rough
Feed
Feed
J
Roughing feedrate.
Tool Type
W
Flat or Ball end mill.