Acu-Rite CNC 3500i User Manual
ACU-RITE 3500i
189
7.
2
C
a
n
n
e
d
C
y
c
le
s
G-code format: G169
Field
Code
Description
FinStock
S
Amount of stock left by the roughing
passes for a finish pass. This amount
applies to the sides and bottom unless M
(SideStock) is defined; then, S (FinStock)
only applies to the bottom. Default is no
stock left.
passes for a finish pass. This amount
applies to the sides and bottom unless M
(SideStock) is defined; then, S (FinStock)
only applies to the bottom. Default is no
stock left.
SideStock
M
Amount of stock left by the roughing
passes for a finish pass on the sides only.
This amount overrides the value in S
(FinStock). A value of zero can force stock
to be left only on the bottom. If entered as
negative, stock is left, but no finish pass
occurs. Default is equal to S (FinStock).
passes for a finish pass on the sides only.
This amount overrides the value in S
(FinStock). A value of zero can force stock
to be left only on the bottom. If entered as
negative, stock is left, but no finish pass
occurs. Default is equal to S (FinStock).
RampFeed
I
The feedrate at which the tool will "ramp"
into the pocket in all three axes. Default is
last programmed feedrate.
into the pocket in all three axes. Default is
last programmed feedrate.
Rough
Feed
Feed
J
Feedrate used during roughing passes.
Default is last programmed feedrate.
Default is last programmed feedrate.
FinFeed
K
Feedrate used during finish passes. If
entered as negative, finish pass will mill in
conventional (CW) direction. Default is last
programmed feedrate.
entered as negative, finish pass will mill in
conventional (CW) direction. Default is last
programmed feedrate.
RetractHgt
P
Z-axis absolute start and finish height (must
be equal to or above "H"), used as a safety/
clearance Z position before making X/Y
moves. Executed in rapid at start and end of
cycle. Defaults to current Z position at
beginning of cycle.
be equal to or above "H"), used as a safety/
clearance Z position before making X/Y
moves. Executed in rapid at start and end of
cycle. Defaults to current Z position at
beginning of cycle.
Coarse
Tool
Tool
T
Number of tool used for previous roughing
cycle.
cycle.
SkipRough
E
Yes = Roughing pass is skipped, only finish
pass is performed.
No = Roughing pass is performed. (Default)
pass is performed.
No = Roughing pass is performed. (Default)
SkipFinish
F
Yes = Finish pass is skipped, only rough
pass is performed.
No = Finish pass is performed. (Default)
pass is performed.
No = Finish pass is performed. (Default)
FinishDir
Q
Select Cw or Ccw.