Toshiba BDRV-WBX8-Z31 Version 7.2.4 M-3 User Manual
- 43 -
2.8 Installation under Windows XP/Server2003 (Parallel interface
with Plug & Play Enabled)
1.
Connect the printer to the PC with a parallel interface cable.
2.
Turn on the printer.
3.
Set the printer parameters in the system mode.
B-SX4, B-SX4-CN, B-SX5, and B-SX5-CN
CENTRO. MODE → ECP
PLUG & PLAY→ ON
B-SA4G, B-SA4G-CN, B-SA4T, B-SA4T-CN, B-852-R, B-452-R, B-SX6T-R, B-SX8T-R, B-EX4T1-G,
B-EX4T1-T, B-EX4T2-G, B-EX4T2-T, and B-EX4T2-H
B-EX4T1-T, B-EX4T2-G, B-EX4T2-T, and B-EX4T2-H
PLUG & PLAY → ON
Note: For the parameter setting procedure, refer to Section 6.2 Parameter Setting on the Printer.
4.
Turn on the PC
Note: Log on as the user with administrative privilege.
5.
After the system is started, new hardware is
detected. When the “Found New Hardware
Wizard” is displayed, select the “Install from a list
or specific location (Advanced)”, then click the
[Next] button.
detected. When the “Found New Hardware
Wizard” is displayed, select the “Install from a list
or specific location (Advanced)”, then click the
[Next] button.
6.
Select the “Search for the best driver in these
locations”, check the “Include this location in the
search” checkbox, then click the [Browse] button.
Specify the folder (C:\TEC_DRV) created in
Section 2.1, and click the [Next] button.
locations”, check the “Include this location in the
search” checkbox, then click the [Browse] button.
Specify the folder (C:\TEC_DRV) created in
Section 2.1, and click the [Next] button.