Sony VGPSTD1 Leaflet

Page of 2
English
WARNING
To reduce the risk of fire or electric shock, do not expose the unit to 
rain or moisture. 
To avoid electrical shock, do not open the cabinet. Refer servicing 
to qualified personnel only.
Owner’s Record
The model number and the serial number are located on the package. Record the serial 
number in the space provided below. Refer to this number whenever you call your Sony 
dealer regarding this product.
Model No. VGP-STD1
Serial No. ____________________
Safety information
  In the following circumstances, remove the battery and have the pen checked by 
qualified personnel before continuing use.
 –  
Water or a foreign object has entered this product.
 –  
Smoke is coming out of this product.
 –  
There is an unusual noise or smell.
 –  
This product is dropped or the exterior of this product has broken.
  Do not place this product in a location subject to:
 –  
On an unstable surface
 –  
In very humid areas or where there is no ventilation
 –  
Excessive dust
 –  
Direct sunlight or extreme heat
 –  
Mechanical vibration or shock
 –  
Greasy fumes
  If this product is brought directly from a cold to a warm location or is placed in a very 
damp room, moisture may condense on the inside of this product. If this occurs, this 
product may not work properly.
  Keep away this product and battery from children.
Precautions on using the dry batteries
  Caution:
 Danger of explosion if battery is incorrectly replaced. Replace only with the same or 
equivalent type recommended by the manufacturer. Discard used batteries according 
to the manufacturer’s instructions.
  If the battery liquid is leaking:
 –  Do not touch the battery liquid directly. If your eyes, skin, or clothing comes into contact with the 
battery liquid, wash well with pure water. If you have skin inflammation or a wound results, 
consult a doctor immediately.
 –  Wipe the battery compartment carefully, and insert new batteries.
  Dispose of used batteries promptly and properly. In some areas, the disposal of 
batteries in household or business waste may be prohibited. Please use the appropriate 
public collection system.
  Batteries may explode or leak if recharged, or disposed of in fire.
  Do not disassemble, heat above 60 ˚C (140 °F) or incinerate.
  Be sure to use batteries specified in “Power requirements” of “Specifications.”
  Insert the batteries with the correct +/– orientation.
  When the batteries have run out, or when you intend to not use this product over a 
prolonged period, remove the batteries.
  Do not short-circuit the metal terminals of the battery or wet them with any liquid, for 
example, water, coffee, or juice.
For customers in the U.S.A.
The following FCC statements apply only to the version of this model 
manufactured for sale in the USA. Other versions may not comply with FCC 
technical regulations.
This equipment has been tested and found to comply with the limits for a Class 
B digital device, pursuant to Part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses, and can radiate radio 
frequency energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or more 
of the following measures:
–  Reorient or relocate the receiving antenna.
–  Increase the separation between the equipment and receiver.
–  Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected.
–  Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for 
compliance could void the user’s authority to operate the equipment.
NOTE: The manufacturer is not responsible for any radio or TV interference 
caused by unauthorized modifications to this equipment. Such modifications 
could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions: (1) this device may not cause harmful interference, 
and (2) this device must accept any interference received, including 
interference that may cause undesired operation.
For customers in Canada
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with RSS-310 of Industry Canada. Operation is subject to 
the condition that this device does not cause harmful interference.
Before Use
This product is a digitizer stylus (pen), designed for use with personal 
computers.
Not all features described in this manual may be available, depending on your 
model.
Before using this product, check your model.
Use of the pen may differ depending on the app. Refer to the manuals provided 
with your computer.
Names of Parts
-
Tail cap
Do not remove the tail cap except for when replacing the battery.
-
  Buttons
Press the lower button to display various pop-up menus, depending 
on the position of the pointer. (This is similar to right-clicking a 
mouse.)
-
  Pen cap
Remove before use, and replace when the pen is not in use or when 
transporting it (to protect the nib).
Note
This pen does not have a power supply switch. Insert a battery in the pen to operate.
Preparations
Insert a battery
When you insert a battery, you can operate the pen.
Replace the battery when the pen begins to function incorrectly.
1
  Remove the tail cap from the barrel of the pen (
).
2
  Insert the battery into the pen with the + side toward the nib 
(
).
3
  Reattach the tail cap.
Notes
  The pen should not be used with a commercially available rechargeable battery. Using a 
rechargeable battery may result in battery leakage and malfunction.
  When the battery power becomes low, replace with a new battery promptly. Keeping a 
depleted battery in the pen may cause battery leakage.
Replacing the nib (tip)
Replace with a new nib (supplied) if the writing is not smooth, or you wish to 
try another shape nib.
1
  Grasp the tip of the pen, then pull out straight (
).
2
  Check the direction of the new nib and insert it into the barrel 
of the pen.
Note
If the pen’s nib is lost or broken, contact an authorized Sony service/support center.
Specifications
Buttons 
 2 buttons
Communication method 
Digital wireless transmission
Power requirements 
LR8D425* (SIZE AAAA) alkaline battery (1)
Battery life 
 Approx. 18 months (alkaline battery) **
Dimensions 
 Approx. 117.0 × 9.5 mm (4.7 × 0.4 in) (length × 
diameter) (including projections)
Mass 
 Approx. 15 g (0.6 oz) (including battery)
Operating temperature 
5 °C to 35 °C (41 °F to 95 °F)
 
 (temperature gradient less than 10 °C (18 °F)/hour)
Operating humidity 
20% to 80% (not condensed), provided that humidity  
is less than 65% at 29 °C (84 °F)
Digitizer Stylus 
VGP-STD1
© 2012 Sony Corporation  Printed in Japan
4-448-458-11(1)
Operating Instructions / Mode d’emploi/ 
Manual de instrucciones
¡IMPORTANTE!
POR FAVOR LEA DETALLADAMENTE ESTE MANUAL DE INSTRUCCIONES ANTES DE CONECTAR Y OPERAR 
ESTE EQUIPO. RECUERDE QUE UN MAL USO DE SU APARATO PODRÍA ANULAR LA GARANTÍA.
Storage temperature 
–20 °C to +60 °C (–4 °F to +140 °F) (temperature 
gradient less than 10 °C (18 °F)/hour)
Storage humidity 
10% to 90% (not condensed), provided that humidity 
is less than 20% of 60 °C (140 °F) (hygrometer 
reading less than 35 °C (95 °F))
Supplied accessories 
LR8D425* (SIZE AAAA) alkaline battery (1 or 2) ***
 
 Pen nib (Tip) (1 or 3) ***
 
 Pen cap (1) (The pen cap is attached to the pen at 
shipment.)
 
 Operating Instructions (this document) (1)
 Alternatively called LR61
**   This estimate is based on four hours of use per day, seven days per 
week. These could differ depending on the usage environment.
***   In the case of a model supplied with personal computers, an alkaline 
battery (1) and pen nib (1) are supplied.
Design and specifications are subject to change without notice.
Français
AVERTISSEMENT
Pour réduire les risques d’incendie ou d’électrocution, n’exposez 
pas l’appareil à la pluie ou l’humidité. 
Pour prévenir les risques d’électrocution, n’ouvrez pas le boîtier. 
Confiez toutes les réparations à un technicien qualifié.
Informations d’identification
Le numéro de modèle et le numéro de série sont indiqués sur l’emballage. Notez le 
numéro de série dans l’espace ci-dessous. Reportez-vous à ce numéro chaque fois que vous 
appelez votre détaillant Sony au sujet de ce produit.
Numéro de modèle VGP-STD1
Numéro de série ____________________
Informations de sécurité
  Dans les situations suivantes, retirez la pile et faites vérifier le stylet par un technicien 
qualifié avant de continuer à l’utiliser.
 –  
De l’eau ou un corps étranger s’est infiltré dans le produit.
 –  
De la fumée s’échappe du produit.
 –  
La souris produit une odeur ou un bruit inhabituel.
 –  
Le produit a fait une chute ou le boîtier extérieur du produit est endommagé.
  Ne placez pas le produit dans un endroit :
 –  
dont la surface est instable;
 –  
situé dans des zones très humides ou mal ventilées;
 –  
soumis à une poussière excessive;
 –  
soumis à la lumière directe du soleil ou à une chaleur extrême;
 –  
soumis à des chocs ou vibrations mécaniques;
 –  
exposé aux fumées huileuses.
  Si le produit est transporté directement d’un endroit froid à un endroit chaud ou s’il est 
installé dans une pièce très humide, de la condensation peut se former à l’intérieur du 
produit. Si cela se produit, le produit peut ne pas fonctionner correctement.
  Gardez le produit et la pile hors de la portée des enfants.
Précautions relatives à l’utilisation des piles sèches
  Attention
 La pile pourrait exploser si elle n’est pas remplacée correctement. Remplacez-les 
uniquement par des piles identiques ou d’un type equivalent recommandé par le 
fabricant. Débarrassezvous des piles usées en suivant les instructions du fabricant.
  En cas de fuite du liquide d’une pile :
 –  
Ne touchez pas directement le liquide de la pile. Si le liquide de la pile entre en 
contact avec vos yeux, votre peau ou vos vêtements, lavez-les bien avec de l’eau claire. 
Si le contact cause une plaie ou une inflammation de la peau, consultez un médecin 
immédiatement.
 –  
Essuyez soigneusement le logement des piles, puis insérez de nouvelles piles.
  Veillez à vous départir des piles usées rapidement et de façon appropriée. Dans 
certaines régions, il est interdit de jeter les piles avec les déchets ménagers ou 
commerciaux. Veuillez utiliser le système de collecte public approprié.
  Les piles peuvent exploser ou fuir lorsqu’elles sont rechargées ou jetées dans les 
flammes.
  Vous ne devez pas les démonter, les exposer à une température de plus de 60 °C  
(140 °F) ou les incinérer.
  La pile pourrait exploser si elle n’est pas remplacée correctement.
  Insérez les piles en respectant la polarité +/–.
  Lorsque les piles sont épuisées ou que vous prévoyez ne pas utiliser le produit pendant 
une période prolongée, retirez les piles.
  Ne court-circuitez pas les bornes métalliques de la pile et ne les mouillez pas avec un 
liquide tel que de l’eau, du café ou du jus.
Pour les clients résidant au Canada
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du 
Canada.
Cet appareil est conforme au CNR-310 d’Industrie Canada. Son exploitation est 
autorisée sous réserve que l’appareil ne cause pas de brouillage préjudiciable.