Avery 204 User Manual
30
C
ONTENTS
3.1 E
LECTRICAL
CONNECTIONS
ALS
20x
256
256
GB
Checking the power supply setting
ALS 256: A power supply setting is not re-
quired.
quired.
The ALS 20X Label Dispenser is suitable for
operation with a power supply of 230 V (AC) or
110 V (AC).
operation with a power supply of 230 V (AC) or
110 V (AC).
If you are unsure of what mains voltage your
local electricity supplier provides, refer to a
qualified service technician.
local electricity supplier provides, refer to a
qualified service technician.
£
Check to see that the voltage that has been set
conforms to the local mains voltage.
conforms to the local mains voltage.
[28] Permissible mains voltages for both positions on the voltage
selector switch.
Changing the voltage setting:
£
Make sure that the power cable is
disconnected.
disconnected.
£
Slide the switch [27A] to the respective
opposite position.
opposite position.
– Insert a small screwdriver into the groove
and
move the red insert horizontally to the opposite stop
position (to the left in Figure
position (to the left in Figure
[27]).
Connecting the power cable.
£
Make sure that the power switch [29A] is set to ‘O’
(off).
(off).
£
Using the supplied power cable, plug the unit into a
socket connected to the mains supply.
socket connected to the mains supply.
For more information on fuses, see section
“Replacing fuses” on page 47.
“Replacing fuses” on page 47.
Switch setting
Permissible mains voltage
115
100–120 V (AC)
230
200–240 V (AC)
[27] Voltage selector switch on the ALS 20X (set to 230 V in the
figure)
A
B
[29] Power cable (B) plugged in.
B
A