Franklin BDS-7100 User Manual

98

This device complies with Part 15 of the FCC Rules. Operation is subject 

to the following two conditions: (1) This device may not cause harmful 

interference, and (2) This device must accept any interference received, 

including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved 

by the party responsible for compliance could void the user’s authority 

to operate the equipment.

Note: This equipment has been tested and found to comply with the 

limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. 

These limits are designed to provide reasonable protection against 

harmful interference in a residential installation. This equipment 

generates, uses and can radiate radio frequency energy and, if not 

installed and used in accordance with the instructions, may cause 

harmful interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular installation. If 

this equipment does cause harmful interference to radio or television 

reception, which can be determined by turning the equipment off and 

on, the user is encouraged to try to correct the interference by one or 

more of the following measures:
1) Reorient or relocate the receiving antenna. 2) Increase the separation 

between the equipment and receiver. 3) Connect the equipment into an 

outlet on a circuit different from that to which the receiver is connected. 

4) Consult the dealer or an experienced radio/TV technician for help.

Note: This unit was tested with shielded cables on the peripheral 

devices. Shielded cables must be used with the unit to insure 

compliance.

Note: The manufacturer is not responsible for any radio or TV 

interference caused by unauthorized modifications to this equipment. 

Such modifications could void the user’s authority to operate the 

equipment.