Zebra Technologies 2237A10L010 User Manual
Routine Maintenance
Cleaning Schedule and Procedures
Cleaning Schedule and Procedures
140
13383L-004 Rev. A
Xi
IIIPlus/R110Xi/R170Xi User Guide
9/6/07
Clean the Snap Plate
Clean the snap plate when label adhesive or a label is stuck to the underside.
The type of snap plate in your printer will depend on whether the printer is standard or
RFID-ready/enabled.
RFID-ready/enabled.
shows the snap plate in a standard non-RFID printer.
shows the location of the snap plate in an RFID-ready XiIIIPlus or in an
R110Xi/R170Xi. Follow the instructions that apply to your printer.
Standard Printers
Figure 27 • Snap Plate for Standard XiIIIPlus Printers
To clean the snap plate in a standard printer, complete these steps:
1.
. Insert a small-blade screwdriver or similar tool into the loop on the left side
of the snap plate.
2.
Gently lift the left side of the snap plate.
3.
Insert a small-blade screwdriver or similar tool into the loop on the right side of the snap
plate.
plate.
4.
Gently lift the right side of the snap plate.
1
Left loop
2
Snap plate
3
Right loop
1
2
3
Important •
Take care not to bend, twist, or otherwise deform the loops. If the snap plate
is damaged in any way, you may need a new plate for proper ribbon sensing.