Zebra Technologies 2237A10L010 User Manual
33
Printer Setup
Connect the Printer to a Power Source
9/6/07
Xi
IIIPlus/R110Xi/R170Xi User Guide
13383L-004 Rev. A
Connect the Printer to a Power Source
The AC power cord must have a three-prong female connector on one end that plugs into the
mating AC power connector at the rear of the printer. If a power cable was not included with
your printer, refer to
mating AC power connector at the rear of the printer. If a power cable was not included with
your printer, refer to
To connect the printer to a power source, complete these steps:
1.
Toggle the printer power switch to the off (O
) position.
2.
Plug the power cord into the AC power connector (
1
) on the rear of the printer.
3.
Plug the other end of the power cord into a power outlet near the printer.
4.
Turn on (I) the printer.
The control panel LCD and lights activate, indicating that the printer is booting up.
Caution •
For personnel and equipment safety, always use an approved three-conductor
power cord specific to the region or country intended for installation. This cord must use an
IEC 320 female connector and the appropriate region-specific three-conductor grounded
plug configuration.
1