Zebra Technologies APL-I User Manual
37
Commands
Configuration Commands
11/24/09
APL-I Reference Guide
14177L-003
Dark Adjust, Set
Purpose To set printer darkness.
Syntax
<SI>dn
Supported
Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Notes
Things to be aware of:
Default: n =
0
Values for n:
+10 is the darkest setting and –10 is the lightest setting, in increments of 1.
Emulation or Advanced Mode on Power-Up
Purpose To choose Emulation or Advanced mode when printer is turned on.
Syntax
<SI>C
Supported
Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Default Value: n = 1
Default Value: n = 1
Values for n:
0 = Emulation mode (10 mil)
1 = Advanced mode (5 mil)
2 = Emulation mode (15 mil)
1 = Advanced mode (5 mil)
2 = Emulation mode (15 mil)
Important This command takes effect after power has been cycled on the printer.
End-of-Print Skip Distance, Set
Purpose To determine the end-of-print skip distance.
Syntax
<SI>Dn
Supported
Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Notes
This command is not usable in self-strip purposes. In order to advance the media to
the tear bar, you have to enter a value for n. This value applies to continuous media and label
stock media. Without entering a value for n, the printer uses the default setting.
stock media. Without entering a value for n, the printer uses the default setting.