Panasonic KX-FC195AL User Manual

Page of 86
10. Help
66
L
The ink film is slack or creased. Tighten it 
(see step 5 on page 15).
DIRECTORY FULL
L
There is no space to store new entries in 
navigator directory. Erase unnecessary 
entries (page 32).
FAX IN MEMORY
L
The unit has a document in memory. See the 
other displayed message instructions to print 
out the document.
FAX MEMORY FULL
L
The memory is full of received documents 
due to a lack of recording paper or a 
recording paper jam. Install paper (page 17) 
or clear the jammed paper (page 70).
L
When performing memory transmission, the 
document being stored exceeded the 
memory capacity of the unit. Transmit the 
entire document manually.
HANG UP HANDSET
L
Handset(s) is not hung up. Press {ih} on 
the handset(s).
MEMORY FULL
L
When making a copy, the document being 
stored exceeded the memory capacity of the 
unit. Press {STOP} to clear the message. 
Divide the document into sections.
MESSAGE FULL
L
There is no room left in memory to record 
voice messages. Erase unnecessary 
messages (page 45, 49).
MODEM ERROR
L
There is something wrong with the modem 
circuit. Contact our service personnel.
NO FAX REPLY
L
The other party’s fax machine is busy or has 
run out of recording paper. Try again.
PAPER JAMMED
L
A recording paper jam occurred. Clear the 
jammed paper (page 70).
PLEASE WAIT
L
The unit is checking that there is no slack or 
crease on the ink film. Wait for a moment 
while the check is completed.
POLLING ERROR
L
The other party’s fax machine does not offer 
the polling function. Check with the other 
party.
REDIAL TIME OUT
L
The other party’s fax machine is busy or has 
run out of recording paper. Try again.
REMOVE DOCUMENT
L
The document is jammed. Remove the 
jammed document (page 72).
SEND CANCELLED
L
You pressed {C} while the unit was in redial 
mode for fax transmission. The redialling was 
cancelled.
TRANSMIT ERROR
L
A transmission error occurred. Try again.
UNIT OVERHEATED
L
The unit is too hot. Let the unit cool down.
Frequently Asked Questions
10.3 When a function does 
not work, check here
If you still have difficulties after following the 
instructions in this section, reset the unit. 
Disconnect the power cord and turn off the 
handset. Remove the batteries, then re-insert 
them. Reconnect the power cord and turn on the 
handset.
10.3.1 General
I cannot make and receive calls.
L
The power cord or telephone line cord is not 
connected. Check the connections.
L
If you used a splitter to connect the unit, 
remove the splitter and connect the unit to the 
wall jack directly. If the unit operates properly, 
check the splitter.
The unit does not work.
L
Disconnect the unit from the telephone line 
and connect the line to a known working 
telephone. If the working telephone operates 
FC195AL.book  Page 66  Tuesday, November 18, 2003  10:28 AM