Barco 26-0503000-00 User Manual
MatrixPRO • 8x8 DVI Router • User’s Guide
93
_K==oÉãçíÉ=`çåíêçä=mêçíçÅçä
RS-232 Mode
opJOPO=jçÇÉ
The MatrixPRO 8x8 DVI Router will respond with a “#” prompt when the command
processor is ready for a command. The command syntax is shown below
processor is ready for a command. The command syntax is shown below
cmd arg1 arg2 … argn<CR>
Please note:
•
A space (ASCII 32) must be inserted between the command and any arguments
that follow. A space must also be inserted between all argument parameters,
except for the last argument in the chain.
that follow. A space must also be inserted between all argument parameters,
except for the last argument in the chain.
•
All commands in RS-232 mode must be terminated with a carriage return (ASCII
13). The carriage return will tell the command processor to begin execution of the
command.
13). The carriage return will tell the command processor to begin execution of the
command.
•
Query commands will return the following:
=result
#
The “=” indicates that a result from a query command is following. The “result” will
follow directly after the “=”. The value of the result will vary depending on the
query command used. A new line will be generated and the prompt (#) will
indicate the system is ready for a new command.
follow directly after the “=”. The value of the result will vary depending on the
query command used. A new line will be generated and the prompt (#) will
indicate the system is ready for a new command.
Table B-1. RS-232 Command Syntax
Command
Description
cmd
Any valid graphics board command, typically 2 to 6 alphabetic (non numeric)
characters
characters
arg
argument1, argument2, … argument"N" are required or optional parameters
depending on the command used.
depending on the command used.
<CR>
carriage return (ASCII 13) terminates the command