Sierra Wireless 300 User Manual
DART 300 Migration Guide
Sample Configurations
2110291 Rev 1.0
Page 7
Table 2-3 Remote TCP Setup (Server) (continued)
DART 200 Command
DART 300 Equivalent
Description
V0 V0
Use numeric result codes.
Q0
(default) Q0
(default)
Disable Quiet mode.
F1
(default)
+WS62=0
Data state echo off.
X1
(default)
N/A
Extended result codes. The DART 300 will
accept the X1 command but takes no action.
accept the X1 command but takes no action.
&C1
(default)
N/A
DCD follows state of connection. The DART 300
uses this configuration and does not allow changes
to DCD function.
uses this configuration and does not allow changes
to DCD function.
&D0
(default)
&D0
Ignore DTR for data state escape.
&E2
S2=43
(Sets TDES escape
character to “+”) (default)
Enable the escape sequence and filter it from the
packet. The DART 300 ensures TDES is enabled;
the DART 300 always filters it from the packet.
packet. The DART 300 ensures TDES is enabled;
the DART 300 always filters it from the packet.
&S0
(default)
N/A
DSR always active. The DART 300 always
asserts DSR.
asserts DSR.
\F3
(default)
Not needed, the next command
would change the setting.
would change the setting.
Includes PAD forwarding character in packet.
\M0
(default)
+WS63=0
Disables PAD forwarding character.
\Q0
Not supported.
The DART 300 supports only
hardware flow control.
The DART 300 supports only
hardware flow control.
No flow control. (See Section 3.1.1 below if
hardware flow control is not provided by your
local host device.)
hardware flow control is not provided by your
local host device.)
\T1
(default)
+WS70=20
Timed data forwarding (always used with binary
data). The DART 200 configuration assumes use
of the default value in S50 (20 tenths of a second).
data). The DART 200 configuration assumes use
of the default value in S50 (20 tenths of a second).
*B0
(default)
N/A
Disable broadcast reception.
*C1
(default)
N/A
Enable SLIP TCP header compression.
*G1
(default)
N/A
Multicast address selection.
*K2
Not supported.
The DART 300 supports only
an idle session timeout (S30).
The DART 300 supports only
an idle session timeout (S30).
Receive keep-alive; unidirectional.
S86=3
Not supported.
The DART 300 supports only a
bi-directional idle session
timeout (S30=3).
The DART 300 supports only a
bi-directional idle session
timeout (S30=3).
Keep-alive timer set to 3 minutes.
With the DART 200 setting of *K2 above, the
DART 300 setting of S30=3 is an equivalent with
the exception that any dummy keep-alive packets
will not be discarded by the DART 300. See
Section 3.2.3.1 below for details.
With the DART 200 setting of *K2 above, the
DART 300 setting of S30=3 is an equivalent with
the exception that any dummy keep-alive packets
will not be discarded by the DART 300. See
Section 3.2.3.1 below for details.
*R0
(default)
N/A Auto-SLIP
disabled.
*T0
(default)
N/A
No Telnet keep-alives.