Sierra Wireless 300 User Manual

Page of 42
DART 300 Modem 
 
Migration Guide 
 
2110291 Rev 1.0 
 
Page ii 
Regulatory Information 
The equipment certifications appropriate to your device are marked on the device and the accompanying product 
specific information.  Where appropriate, the use of the equipment is subject to the following conditions: 
 
 
CAUTION 
Unauthorized modifications or changes not expressly approved by Sierra Wireless, Inc. 
could void compliance with regulatory rules, and thereby your authority to use this 
equipment. 
 
 
WARNING (EMI) - United States FCC Information 
This equipment has been tested and found to comply with the Class B limits pursuant to 
Part 15 of the FCC Rules.  These limits are designed to provide reasonable protection 
against harmful interference in an appropriate installation.  This equipment generates, 
uses, and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio 
communication.  However, there is no guarantee that interference will not occur in a 
particular installation.  If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the 
user is encouraged to try to correct the interference by one or more of the following 
measures: 
• 
Reorient or relocate the receiving antenna 
• 
Increase the separation between the equipment and receiver 
• 
Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected 
• 
Consult the dealer or an experienced radio/TV technician for help 
 
 
 
WARNING – FCC RF Exposure Guidelines 
While this device is in operation, a separation distance of at least 20cm must be 
maintained between the radiating antenna and the body of all persons exposed by the 
transmitter to meet FCC exposure guidelines. 
This transmitter is only approved to operate with an antenna not exceeding 1.5 watts 
total system ERP (effective radiated power) for operations with the antenna located at 
more than 20 cm from all persons.  The warning label must be displayed at the base of 
the antenna (if stand-alone) or attached to the final product (if the antenna is integral 
with the product), clearly visible to all persons exposed to the transmitter. 
 
 
WARNING (EMI) – Canada 
This digital apparatus does not exceed the Class B limits for radio noise emissions 
from digital apparatus as set out in the interference causing equipment standard 
entitled 'Digital Apparatus', ICES-003 of the Department of Communications. 
Cet appareil numérique respecte les limites de bruits radioélectriques applicables aux 
appareils numériques de Classe B prescrites dans la norme sur le matériel brouilleur:  
'Appareils Numériques', NMB-003 édictée par le ministre des Communications.