Netgear FVS318N User Manual
Introduction
18
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Rear Panel
The rear panel of the wireless VPN firewall includes the antennas, a cable lock receptacle, a
console port, a Reset button, a DC power connection, and a power switch.
console port, a Reset button, a DC power connection, and a power switch.
Figure 2.
Viewed from left to right, the rear panel contains the following components:
1.
Dipole antenna.
2.
Cable security lock receptacle.
3.
Console port. Port for connecting to an optional console terminal. The port has a DB9 male
connector. The default baud rate is 9600 K. The pinouts are (2) Tx, (3) Rx, (5) and (7) Gnd.
connector. The default baud rate is 9600 K. The pinouts are (2) Tx, (3) Rx, (5) and (7) Gnd.
4.
Factory default Reset button. Using a sharp object, press and hold this button for about
8 seconds until the front panel Test LED flashes to reset the wireless VPN firewall to factory
default settings. All configuration settings are lost, and the default password is restored.
8 seconds until the front panel Test LED flashes to reset the wireless VPN firewall to factory
default settings. All configuration settings are lost, and the default password is restored.
5.
DC power plug receptacle. Power input is 12VDC, 1A. The power plug is localized to the
country of sale.
country of sale.
6.
Power On/Off switch.
7.
Dipole antenna.
(2) Security lock
receptacle
(3) Console port
(4) Factory default
(5) DC power
receptacle
Reset button
Antennas
(6) Power
(1) and (7)
switch