Netgear FVS318N User Manual

Any of the following table buttons might display onscreen:

Select All. Select all entries in the table.

Delete. Delete the selected entry or entries from the table.

Enable. Enable the selected entry or entries in the table.

Disable. Disable the selected entry or entries in the table.

Add. Add an entry to the table.

Edit. Edit the selected entry.

Up. Move the selected entry up in the table.

Down. Move the selected entry down in the table.

Apply. Apply the selected entry.

Almost all screens and sections of screens have an accompanying help screen. To open the 
help screen, click the 

 (question mark) icon.

Requirements for Entering IP Addresses

To connect to the wireless VPN firewall, your computer needs to be configured to obtain an IP 
address automatically from the wireless VPN firewall, either an IPv4 address through DHCP 
or an IPv6 address through DHCPv6, or both.

The fourth octet of an IP address needs to be between 0 and 255 (both inclusive). This 
requirement applies to any IP address that you enter on a screen of the web management 
interface.

IPv6 addresses are denoted by eight groups of hexadecimal quartets that are separated by 
colons. Any four-digit group of zeroes within an IPv6 address can be reduced to a single zero 
or altogether omitted.

The following errors invalidate an IPv6 address:

More than eight groups of hexadecimal quartets

More than four hexadecimal characters in a quartet

More than two colons in a row