Rosewill RM1670 User Manual

 

6

… 

Q: The mouse cursor can only move left & right during operation (it could   

be caused by low battery or the optical sensor’s data error).   

A: Please take out one of batteries and put it back for a power reset and 

then redo the connect procedure. 

… 

Q: The mouse does not work after waking up from power off mode by 

pressing the connect button once. 

A: This might be caused by imprecisely depressing the connect button to 

wake up the mouse. Users can gain back normal operation by pressing 

connect button on the mouse first, and then pressing the one on the receiver. 

As soon as the LED inside the receiver starts flashing, the mouse is ready to 

operate. 

„  Reducing Interference with Other Wireless Devices: 

All 27MHz radio-based devices are subject to interference from other 27MHz 

radio-based devices, such as cordless telephones, cordless baby monitors, and 

cordless toys. It may help to move the receiver unit and the base unit of other 

wireless devices (such as cordless telephone cradle) as far apart as possible. You 

may need to try several times for a location that is best in your operating 

environment. 

„ Move the receiver and the mouse closer to each other so that the receiver is 

relatively shorter in distance to the mouse than to other 27MHz transmitters. 

You may need to re-establish the “connection”. 

Note: Avoid using this device on a metal surface because a large surface of iron, 

aluminum, copper, or other metal may act like a shielding to the RF antenna of the 

mouse and the receiver. 

    If the interference comes from other same model of RF wireless mice, please 

“Setting up connection between mouse and receiver” of the installation guide to 

switch to a new RF channel. A new identification code is also generated upon the 

completion of channel switching.