Sony 1080i User Manual

Chapter 3   Dubbing/Editing

Chapter 3

Dubbing/Editing

35

Rear view of the player
(this unit)

Monitor

i.LINK cable (not supplied)

i.LINK jack

Digital video
equipment with an
i.LINK jack

: Signal flow

Monitor

Chapter

3

This section describes the connections and settings
necessary to perform dubbing on other equipment,
using this unit as a video player.

• For connection of the editing controller and its

peripheral devices, refer to the instruction manual of
the editing controller and that of the editing software
you use.

• Edit functions are specified by the editing software.

For details on the editing methods, refer to the
instruction manual of the editing software.

• You cannot use the DSR-25/45-equipped duplicate

function to dub a tape recorded in HDV/DV format
via the i.LINK connection.  Use the procedure in this
chapter to perform dubbing.

Connect this unit to the recorder as shown below using
an i.LINK cable.
The signal flow is automatically detected so you do not
need to make separate connections for input and
output. Also, connecting the unit to an editing
controller via   HDV/DV jacks, you can configure a
digital non-linear editing system.

Before dubbing, you must set the format in which you
want to output signals. Perform the [VCR HDV/DV]
(p. 48) and [i.LINK CONV] (p. 49) settings of the [IN/
OUT REC] menu.