ONKYO ABX-N300 User Manual

En-

33

If you experience any problem while using the 
ABX-N300, look for a solution in this section.

• Make sure that the AC adapter is properly plugged 

into the wall outlet, and that the DC IN connection has 
been made correctly (see page 13).

• Unplug the AC adapter from the wall outlet, wait ten 

seconds or more, then plug it in again.

• If the sleep timer has been set and the SLEEP 

indication is shown on the display, the ABX-N300 
will turn off automatically after a specified period 
(see page 25).

• When timed playback finishes, the ABX-N300 

automatically switches to standby mode 
(see page 24).

• It will take some time for functions related to the 

network or to your iPod/iPhone to begin operating.

• If you set “Standby Mode” (see page 30) to 

“Network,” the power consumption while in standby 
mode will increase, but operation will begin 
immediately when you turn the power on.

• Make sure the ABX-N300’s volume is not set too low 

(see page 14).

• Make sure the correct input source is selected 

(see page 14).

• Make sure the ABX-N300 is not muted (see page 14).
• Check all connections and correct as necessary 

(see page 13).

• The sound quality can be affected by strong magnetic 

fields, such as that from a TV. Try moving any such 
devices away from the ABX-N300.

• If you have any devices that emit high-intensity radio 

waves near the ABX-N300, such as a cellular phone 
that’s being used to make a call, the ABX-N300 may 
output noise.

• Adjust the tone to your taste or according to the audio 

source by activating S.Bass (see page 15).

• Allow a space of 20 cm or more on each side of the 

unit (see page 11).

• Make sure that your iPod/iPhone is playing.
• Make sure your iPod/iPhone is properly seated in the 

ABX-N300’s iPod dock. (see pages 9 and 16).

• Disconnect your iPod/iPhone from the dock, and then 

firmly insert it back into the dock.

• Make sure the ABX-N300 is turned on, the input 

source is set to iPod, and the volume is not set too low.

• If your iPod or iPhone is in a case, remove the case 

before inserting the iPod or iPhone (see page 9).

• Make sure your iPod/iPhone is properly seated in the 

ABX-N300’s iPod dock. Even very thin iPod/iPhone 
cases can prevent the iPod/iPhone from seating 
properly on the dock connector, so always remove any 
case before inserting your iPod/iPhone 
(see pages 9 and 16).

• Disconnect your iPod/iPhone from the dock, and then 

firmly insert it back into the dock.

• Depending on your iPod/iPhone model, its software 

version, or the content your playing, some functions 
may not work as expected (see pages 9 and 16).

If a problem occurs with the ABX-N300’s operation, you 
may be able to solve the problem by resetting the unit.

Before you request service, please reset the 
ABX-N300 as described below.

2. Use the []/[] buttons to select “Reset,” and 

press the [ENTER] button.
The screen will indicate “Cancel.”

4. To reset, use the []/[] buttons to select 

“Settings,” and press the [ENTER] button.
All settings other than the network settings will 
return to their factory-set state, and the 
ABX-N300 will enter standby mode.

Note:
Selecting “Network” and then pressing the 
[ENTER] button will reset network-related 
functions. Perform this reset operation ONLY 
when the unit’s network or iPod/iPhone does not 
function properly.