Royal Sovereign 1050 User Manual

4. After pressing the                    button  choose and set proper speed by using
    the                and                                   button.
5. It is                when ready is show on the screen and the buzzer rings three times.

sound three times.

6. Turn on the take up device and set the proper film tension by pressing the 
                 button. Lower tension would make better operation.

7. Set document on the table. 
You should allow at least 5mm(1/4”) 
space on each side for perfect laminations
8. Turn the switch “Run” and 
    “take up motor” at the same time.
    The liner and film will be rolled at 
    the same time.
9. When lamination is finished, press the 
                button. For your convenience,
 it would be better to set table guide in
 proper position. And if needed, 
 cut documents with cross cutter.

10. Set pressure lever at the Hard board/15mm mode.
11. Turn off the power switch.

1. Set up the protection paper. Otherwise, glue form the film will be stuck on the face
    of roller and it can be seriously damaged.
2. Turn the switch “Run” and “Take up motor” at the same time.
3. For worm lamination, set temperature from the hot mode.

1. It is convenient to use the remote control in the back of machine while laminating.
2. It is also convenient if you use Foot Switch while laminating HARD BOARD.
3. "RUN", "STOP", "REV" buttons on Remote Control have same functions 

with the ones on Control Panel.

RUN

STOP

 

- 22 -