SEAL 44Ultra Laminator User Manual
Troubleshooting
42
Problem:
The quality of the lamination is poor: wrinkles and/or creases show up in the output.
The quality of the lamination is poor: wrinkles and/or creases show up in the output.
Cause:
The laminating pressure setting is wrong.
The laminating pressure setting is wrong.
Solution:
Perform the Laminating Pressure Adjustment Procedure described in
Section 5-1.
Perform the Laminating Pressure Adjustment Procedure described in
Section 5-1.
Miscellaneous Control System Board Error Messages
Error:
LED no. L6 is NOT lit.
Cause:
The +5V voltage is not present.
The +5V voltage is not present.
Solution:
Check the fuses F1, F2 and F3.
If OK, check if there are no loose connections in the cable harness.
If this is OK as well, replace the Control System Board.
Check the fuses F1, F2 and F3.
If OK, check if there are no loose connections in the cable harness.
If this is OK as well, replace the Control System Board.
Error:
LED no. L7 is NOT lit.
Cause:
The voltage for the motorcontroller is not present.
The voltage for the motorcontroller is not present.
Solution:
Check the Emergency Stops.
If OK, check if there are no loose connections in the cable harness.
If this is OK as well, replace the Control System Board.
Check the Emergency Stops.
If OK, check if there are no loose connections in the cable harness.
If this is OK as well, replace the Control System Board.