SEAL 600-C User Manual
15
S E T - U P A N D O P E R A T I O N
AUTO-RUN OPERATION
•
The continuous-run operation allows the user to
start the roller rotation and adjust the roller speed
start the roller rotation and adjust the roller speed
by turning the Speed Control knob on the control
panel.
IMPORTANT! If the photoelectric eyes
become blocked during continuous-run
panel.
IMPORTANT! If the photoelectric eyes
become blocked during continuous-run
operation, the roller rotation will stop
immediately.
immediately.
IMPORTANT! Take care not to stop the motor
or block the photoelectric eyes while an image
or block the photoelectric eyes while an image
is being laminated as this can cause marks in
the output.
the output.
FOOTSWITCH OPERATION
•
The function of the footswitch is to permit the
rotation of the rollers to be controlled in a hands-
rotation of the rollers to be controlled in a hands-
free manner.
•
This feature can be used when webbing materials
onto the laminator or feeding delicate images and
overrides the photoelectric safety eyes.
overrides the photoelectric safety eyes.
•
The speed can be adjusted when using the
footswitch by turning the speed control knob on
the control panel.
WARNING! On Domestic version laminators,
the foot switch overrides the photoelectric eyes.
footswitch by turning the speed control knob on
the control panel.
WARNING! On Domestic version laminators,
the foot switch overrides the photoelectric eyes.
Interrupting the photoelectric safety eyes does
NOT stop the laminator when using the
NOT stop the laminator when using the
footswitch. A BUZZER will sound, warning of
close proximity to the nip. Use care to keep
close proximity to the nip. Use care to keep
hands clear of the rollers while using the foot
switch to prevent possible injury.
switch to prevent possible injury.
•
After clearing the photoelectric eye blockage the
buzzer will stop.
buzzer will stop.
•
Releasing the foot switch will stop the laminator.
CHANGING FROM FOOTSWITCH OPERATION
TO AUTO-RUN MODE WITHOUT STOPPING
(
TO AUTO-RUN MODE WITHOUT STOPPING
(
TO PREVENT STOP MARKS ON THE SUBSTRATE
):
•
During footswitch operation (keep the foot switch
pressed), then press the motor switch.
pressed), then press the motor switch.
•
Next, release the foot switch.
IMPORTANT! Do not stop the motor or block
IMPORTANT! Do not stop the motor or block
the photoelectric eyes while an image is being
laminated as this can cause marks in the
laminated as this can cause marks in the
output.
THE ROTATION OF THE ROLLERS WILL
STOP WHEN:
STOP WHEN:
•
The photoelectric eyes in the front of the rollers are
interrupted.
NOTE! This does NOT happen when the foot
interrupted.
NOTE! This does NOT happen when the foot
switch is used on Domestic version laminators.
•
An emergency stop button is pressed.
•
The motor switch is pressed OFF.