SEAL 600-C User Manual

A P P L Y I N G A N O V E R - L A M I N A T E

An Over-laminate with a release liner can be applied to
your mounted prints, photographs or images on

photographic papers. A Sled (refer to Glossary) is
needed to support non-mounted prints during the

laminating process. Non-mounted prints are placed face
up on the sled and over-laminated as the sled passes

through the rollers. Follow the same basic procedures
for over-laminating mounted prints, eliminating the sled

use.
For double-sided laminating (encapsulating), over-

laminate and trim the first side and then repeat the
process for the second side.

MEDIA: I

, E

LECTROSTATIC

AND

HOTOGRAPHIC

FILMS:

Top Unwind: Pressure-sensitive Adhesive
Bottom Unwind: NA

LAMINATOR SETTINGS:

FRONT CONTROL PANEL

Main Roller Pressure:

35-40 PSI

Motor Speed Setting:

3-5 FPM (1-1.5 MPM)

WEBBING SETTINGS

Web Tension Top:

Light

Web Tension Bottom:

Shim Wheel Setting:

Substrate determined

IMPORTANT! Ensure that the Shim Wheel

settings of the rollers correspond to the board /
sled thickness.
NOTE! Web the top laminate following the basic
procedures for webbing films with a release liner

for your specific location.

NOTE: When over-laminating mounted prints, or
non-mounted prints on sleds, ensure that the board

follows directly behind the leader board without
any gaps.

NOTE: Follow the last board being processed with

another leader-board again to allow the final board
to clear the laminating rollers and then stop the

motor and raise the top roller.

Figure 16. Webbing for

Applying an Over-laminate

for North America

Figure 17. Webbing for

Applying an Over-laminate

for Europe & Asia

U n w i n d
S h a f t

TOP
ROLLER

BOTTOM

ROLLER

Wind-Up
Idler

Sled

U n w i n d
S h a f t

Image

Pressure-Sensitive Over-Laminate

Release Liner

U n w i n d

S h a f t