Motorola MT2090 User Manual
User Preferences & Miscellaneous Scanner Options 5 - 11
Hand-Held Trigger Mode
Parameter # 8Ah
Select one of the following trigger modes for the device:
•
Standard (Level) - A trigger pull activates decode processing. Decode processing continues until the bar
code decodes, you release the trigger, or the Decode Session Timeout occurs.
code decodes, you release the trigger, or the Decode Session Timeout occurs.
•
Presentation (Blink) - The device activates decode processing when it detects a bar code in its field of view.
After a period of non-use, the device enters a low power mode, in which the LEDs turn off or blink at a low
duty cycle until the device senses motion.
After a period of non-use, the device enters a low power mode, in which the LEDs turn off or blink at a low
duty cycle until the device senses motion.
Decode Session Timeout
Parameter # 88h
This parameter sets the maximum time decode processing continues during a scan attempt. It is programmable in
0.1 second increments from 0.5 to 9.9 seconds. The default timeout is 9.9 seconds.
0.1 second increments from 0.5 to 9.9 seconds. The default timeout is 9.9 seconds.
that correspond to the desired on time. Enter a leading zero for single digit numbers. For
example, to set a Decode Session Timeout of 0.5 seconds, scan the bar code below, then scan the 0 and 5 bar
codes. To correct an error or change the selection, scan
codes. To correct an error or change the selection, scan
.
NOTE
Laser scanning is not applicable in hand-held presentation mode.
*
Standard (Level)
(00h)
Presentation (Blink)
(07h)
Decode Session Timeout