Panasonic CF53JBLZY1M User Manual

22

“Remove disks or other 
media. Press any key to 
restart” or a similar mes-
sage appears.

z

A floppy disk in the drive or USB memory is connected, and it does not contain sys-
tem startup information. Remove the floppy disk and USB memory, then press any 
key.

z

If a device is connected to the USB port, disconnect the device, or set [USB Port] or 
[Legacy USB Support] to [Disabled] in the [Advanced] menu of the Setup Utility.

z

If a device is connected to the ExpressCard slot, disconnect the device, or set [Express-
Card Slot] to [Disabled] in the [Advanced] menu of the Setup Utility.

z

<Only for model with ExpressCard slot>
If the problem persists after removing the disk, it may be a hard disk failure. Contact 
Panasonic Technical Support (Πpage 33).

Windows startup and opera-
tion is slow.

z

Press F9 in the Setup Utility (Î

 Reference Manual “Setup Utility”) to return the 

Setup Utility settings (excluding the passwords) to the default values. Start the 
Setup Utility and make the settings again. (Note that the processing speed depends 
on the application software, so this procedure may not make Windows faster.)

z

If you installed a resident software after purchase, turn off the residence.

z

 Disable Indexing Service in the following menu.

Click [start] - [Search] - [Change preferences] - [With Indexing Service (for faster 
local searches)].

The date and time are incor-
rect.

z

Make the correct settings. 

Click 

 (Start) - [Control Panel] - [Clock, Language, and Region] - 

[Date and Time].
Click [start] - [Control Panel] - [Date, Time, Language, and Regional 
Options] - [Date and Time].

z

If the problem persists, the internal clock battery may need to be replaced. Contact 
Panasonic Technical Support (Πpage 33).

z

When the computer is connected to LAN, check the date and time of the server.

z

The 2100 A.D. or later year will not be correctly recognized on this computer.

[Executing Battery Recali-
bration] screen appears.

z

The Battery Recalibration was canceled before Windows was shut down last time. 
To start up Windows, turn off the computer by the power switch, and then turn on.

[Enter Password] does not 

appear when resuming from 
sleep (

)/

standby (

)/

hibernation.

z

Select [Enabled] in [Password On Resume] in the [Security] menu of the Setup Utility 
(Î

 Reference Manual “Setup Utility”).

z

The Windows password can be used instead of the password set in the Setup Utility.

 

A

Click 

 (Start) - [Control Panel] - [User Accounts and Family Safety] - [Add or 

remove user accounts] and select the account, and set the password.

B

Click 

 (Start) - [Control Panel] - [System and Security] - [Power Options] - 

[Require a password on wakeup] and add a check mark for [Require a 

password].

 

A

Click [start] - [Control Panel] - [User Accounts] and select the account, and set 

the password.

B

Click [start] - [Control Panel] - [Performance and Maintenance] - [Power Options] 

- [Advanced] and add a check mark for [Prompt for password when computer 

resumes from standby].

Cannot resume.

z

An error may occur when the computer automatically enters the sleep or hibernation 
mode while the screen saver is active. In this case, turn off the screen saver or change 
the pattern of the screen saver.

„

DFQW5496ZAT_CF-53mk1_XP7_OI_EN.book  22 ページ  ２０１１年３月２２日　火曜日　午後７時２４分