Panasonic CF53JBLZY1M User Manual

5

z

Reorient or relocate the receiving antenna.

z

Increase the separation between the equipment and 

receiver.

z

Connect the equipment into an outlet on a circuit differ-

ent from that to which the receiver is connected.

z

Consult the Panasonic Service Center or an experi-

enced radio/TV technician for help.

Warning
To assure continued compliance, use only shielded inter-

face cables when connecting to a computer or peripheral.

Also, any changes or modifications not expressly 

approved by the party responsible for compliance could 

void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, 

including interference that may cause undesired oper-

ation.

FCC RF Exposure Warning:
z

This equipment is provided with PC Card slot that 

could be used with wireless transmitters, which will be 

specifically recommended when they become avail-

able.

Other third-party wireless transmitters have not been 

RF exposure evaluated for use with this computer and 

may not comply with FCC RF exposure requirements.

<Only for model with wireless LAN/Bluetooth>

z

This equipment complies with FCC radiation exposure 

limits set forth for an uncontrolled environment.

z

This equipment has been approved for mobile opera-

tion, and unless otherwise advised in separate supple-

mental instructions for individual wireless 

transmitter(s), requires minimum 20cm spacing be pro-

vided between antenna(s) and all person’s body 

(excluding extremities of hands, wrist and feet) during 

wireless modes of operation.

z

This equipment may not be co-located or operated 

with any other antenna or transmitter.

25-M-6

<Only for model with wireless LAN>

This product is restricted to indoor use due to its operation in the 

5.15 to 5.25 GHz frequency range.

FCC requires this product to be used indoors for the frequency 

range 5.15 to 5.25 GHz to reduce the potential for harmful inter-

ference to co-channel Mobile Satellite systems. High power 

radars are allocated as primary users of the 5.25 to 5.35 GHz 

and 5.65 to 5.85 GHz bands. These radar stations can cause 

interference with and/or damage this product.

25-M-W-6

Responsible Party: Panasonic Corporation of North Amer-

ica One Panasonic Way

Secaucus, NJ 07094

Tel No:1-800-LAPTOP5 (1-800-527-8675)

6-M-1

1. This equipment complies with CFR47 Part 68 rules.

On the computer is a label that contains, among other infor-

mation, the FCC registration number and ringer equivalence 

number (REN) for this equipment. If required, this informa-

tion must be provided to the telephone company.

2. An FCC compliant telephone cord and modular plug is pro-

vided with this equipment. This equipment is designed to be 

connected to the telephone network or premises wiring using 

a compatible modular jack which is Part 68 compliant. See 

Installation Instructions for details.

3. The REN is used to determine the quantity of devices which 

may be connected to the telephone line. Excessive RENs on 

the telephone line may result in the devices not ringing in 

response to an incoming call. In most, but not all area, the sum 

of RENs should not exceed five (5.0). To be certain of the num-

ber of devices that may be connected to a line, as determined 

by the total RENs, contact the local telephone company.

4. If your telephone equipment cause harm to the telephone 

network, the telephone company will notify you in advice 

that temporary discontinuance of service may be 

required. But if advice notice isn’t practical, the telephone 

company will notify the customer as soon as possible. 

Also, you will be advised of your right to file a complaint 

with the FCC if you believe it is necessary.

5. The telephone company may take changes in its facili-

ties, equipment, operations or procedures that could 

affect the operation of the equipment. If this happens 

the telephone company will provide advance notice in 

order for you to make necessary modifications to 

maintain uninterrupted service.

6. If trouble is experienced with this equipment, for repair or 

warranty information, please contact Panasonic Corporation 

of North America at DIAL TOLL FREE 1-800-LAPTOP5 (1-

800-527-8675). If the equipment is causing harm to the tele-

phone network, the telephone company may request that 

you disconnect the equipment until the problem is resolved.

7. There are no user serviceable parts contained in this 

equipment.

8. This equipment may not be used on coin service pro-

vided by the telephone company. Connection to party 

lines is subject to state tariffs.

9. The Telephone Consumer Protection Act of 1991 makes it 

unlawful for any person to use a computer or other electronic 

device to send any message via a telephone fax machine 

unless such message clearly contains in a margin at the top 

or bottom of each transmitted page or on the first page of the 

transmission, the date and time it is sent and an identification 

of the business or other entry, or other individual sending the 

message and the telephone number of the sending machine 

or such business, other entity, or individual. In order to pro-

gram this information into your fax software, you should refer 

to the manual of the Fax software being used.

10.According to the FCC’s electrical safety advisory, we 

recommend that you may install an AC surge arrestor 

in the AC outlet to which this equipment is connected.

Telephone companies report that electrical surges, typ-

ically lightning transients, are very destructive to cus-

tomer terminal equipment connected to AC power 

sources and that this is a major nationwide problem.

“Caution : To reduce the risk of fire, use only No.26 AWG 

or larger (e.g., 24 AWG) UL listed or CSA certified tele-

communication line cord.”

“ATTENTION : Pour réduire le risque d’incendie, utiliser 
uniquement des conducteurs de télécommunications 26 
AWG ou de section supérieure (p. ex. 24 AWG) UL 
énumérés ou CSA certifié.”

16-M-1

DFQW5496ZAT_CF-53mk1_XP7_OI_EN.book  5 ページ  ２０１１年３月２２日　火曜日　午後７時２４分