Eclipse - Fujitsu Ten D2140 User Manual

 

Adding PCI cards 

A26361-D2140-Z120-1-7419, edition 1 

English - 21 

 

 

To achieve optimum stability, performance and compatibility, avoid the multiple use of ISA 
IRQs or PCI IRQ Lines (IRQ sharing). Should IRQ sharing be unavoidable, then all 
involved devices and their drivers must support IRQ sharing. 

 

PCI IRQ Lines connect AGP slots, PCI slots and onboard components to the interrupt controller. PCI 
IRQ Lines are permanently wired on the mainboard. 
Which ISA IRQs are assigned to the PCI IRQ Lines is normally automatically specified by the BIOS 
(see description in "BIOS Setup"). 

Monofunctional expansions cards: 
Standard AGP and PCI expansion cards require a maximum of one interrupt, which is called the PCI 
interrupt INT A. Expansion cards that do not require an interrupt can be installed in any desired slot. 

Multifunctional expansion cards or expansion cards with integrated PCI-PCI bridge: 
These expansion cards require up to four PCI interrupts: INT A, INT B, INT C, INT D. How many and 
which of these interrupts are used is specified in the documentation provided with the card. 
The assignment of the PCI interrupts to the PCI IRQ Lines is shown in the following table: 

- - - - +

-

-

-

B

C

D

-

- - 

- - - - - - - - C D A - - - 

-  -  - -  - + + - D A B -  -  - 

- -  - - - - - + A B C - - - 

+ - - - - - - - - - - - - - 

- + - - - - - - - - - - - - 

- - + - - - - - - - - - - - 

- - - + - - - - - - - - - - 

 

Use the first PCI slots that have a single PCI IRQ Line (no IRQ sharing). If you must use another PCI 
slot with IRQ sharing, check whether the expansion card properly supports IRQ sharing with the 
other devices on this PCI IRQ Line. The drivers of all cards and components on this PCI IRQ Line 
must also support IRQ sharing.