Epson Y16499100301 User Manual

When you finish using the Setup program, press   until the

cursor block is on Exit and press 

Enter. 

The screen displays a

list of the current settings you just made. Check the list to

make sure all the information is correct.

Below the list you see this menu:

Change settings

Exit 

without saving

* * EXIT AND SAVE * *

If any setting is incorrect, press 

Enter. 

The main Setup menu

is displayed again, and you can correct the setting.

If you did not make any changes or if you want to cancel

the changes you made, press   to select 

Exit 

without 

saving,

and press 

Enter.

When the settings are correct, press   to select * * EXIT

AND SAVE * *, and press 

Enter. 

At this point, the program

resets the computer using the new configuration. If the

reference diskette is in drive A, remove it and insert the
MS-DOS diskette in the drive.

If the computer displays a Setup error message during the

power-on self test, run Setup again and check all your settings.

Note

If you have the hard disk model Equity LT, go on to
Chapter 2 and complete all the procedures there to prepare
your hard disk for use. If you do not have a hard disk, go on

to Chapter 3.