Epson 386/33 PLUS User Manual

The instructions in this chapter describe how to install and

remove optional Epson drives in your computer. You can use

these instructions to install a variety of devices, including

diskette drives, hard disk drives, and tape drives. Although

your drive may look a bit different from the one illustrated

here, you install it the same way.

If you are installing or removing a non-Epson drive, some of

the steps in this chapter may not apply; see the documentation

that came with your drive for more information.

Before you perform any of the procedures described below,

follow the steps in Chapter 3 to remove the computer’s cover

and subassembly.

When you complete your drive installation or removal, follow

the instructions in Chapter 3 to replace the subassembly and

cover. Then see “Post-installation Setup Procedures” at the end

of Chapter 4 for information about updating the SETUP

program with your new drive configuration.

Installing or removing a disk drive is a complicated

procedure, so you may want to ask your dealer to do it for

you. If you decide to do it yourself, follow all the

instructions in this chapter carefully, or you could damage

your system.