Psion Teklogix 7530 G2 User Manual
Psion Teklogix 7530 G2 Hand-Held Computer User Manual
13
Chapter 2: Basic Checkout
Preparing The 7530 G2 For Operation
2.1 Preparing The 7530 G2 For Operation
Typically, 7530 G2 hand-helds are configured at the factory and arrive ready for use.
Although these hand-helds are equipped with an internal Compact Flash and SD I/O
slot, these slots are not intended for user modification. If a device needs to be
changed or added in these slots, contact qualified Psion Teklogix personnel. Refer to
Appendix A: Support Services And Worldwide Offices for service information.
Although these hand-helds are equipped with an internal Compact Flash and SD I/O
slot, these slots are not intended for user modification. If a device needs to be
changed or added in these slots, contact qualified Psion Teklogix personnel. Refer to
Appendix A: Support Services And Worldwide Offices for service information.
2.1.1 Equipment You Need To Get Started
You’ll need:
•
A compatible battery charger, docking station or portable docking module
(PDM) with power supply.
(PDM) with power supply.
•
An operating wireless network (if you are not operating the equipment in
batch mode).
batch mode).
•
A #2 Phillips head screwdriver (if you need to attach a carrying strap or
pistol grip handle).
pistol grip handle).
2.1.2 Charging The Battery
Important:
The 7530 G2 uses a high capacity Lithium-Ion battery. It is criti-
cal that you review the battery safety guidelines in “Lithium-Ion
Battery Safety Precautions” on page XII before charging
the battery.
cal that you review the battery safety guidelines in “Lithium-Ion
Battery Safety Precautions” on page XII before charging
the battery.
Batteries shipped from the factory are not charged. They must be fully charged prior
to use. Full capacity may not be reached until at least 5 full charge/discharge cycles
have been performed.
Batteries can be charged using a gang charger or the unit’s internal charger. When
using the internal charger, a suitable power source is required. All chargers and
docking stations are described in Chapter 6: Peripheral Devices & Accessories
beginning on page 213.
to use. Full capacity may not be reached until at least 5 full charge/discharge cycles
have been performed.
Batteries can be charged using a gang charger or the unit’s internal charger. When
using the internal charger, a suitable power source is required. All chargers and
docking stations are described in Chapter 6: Peripheral Devices & Accessories
beginning on page 213.
Note: The 7530 G2 Battery Properties dialog box may indicate an incorrect bat-
tery capacity until the new battery has been fully charged.
It may take several charge/discharge cycles for the battery capacity
gauge to register capacity with the full 95% accuracy.
gauge to register capacity with the full 95% accuracy.