Toshiba TECRA M5 User Manual
User’s Manual
9-21
Troubleshooting
Printer
Refer also to the
sections in Chapter 8,
, and to
the troubleshooting and other relevant sections in your printer and software
documentation.
An Advanced Port Replicator III Plus is equipped with a parallel port.
An Advanced Port Replicator III Plus is equipped with a parallel port.
TV output signal
Problem
Procedure
Printer does not turn on. Check that the printer is connected to an electric
outlet. Make sure the outlet is supplying power by
plugging in an appliance.
Computer/printer do not
communicate
Make sure the printer is turned on and is online
(ready to use).
Inspect the cable connecting the printer to the
Inspect the cable connecting the printer to the
computer for damage. Make sure it is securely
connected.
A parallel printer connects to the parallel port.
A parallel printer connects to the parallel port.
Make sure the port is configured correctly.
Make sure your software is configured to
Make sure your software is configured to
recognize the printer. Check your printer and
software documentation.
Printer error
Check your printer documentation.
If problems persist, contact your dealer.
If problems persist, contact your dealer.
Problem
Procedure
Display on TV is poor
Make sure the TV type is correct for your area:
NTSC (US, JAPAN), PAL (Europe).
No display
Try adjusting the contrast and brightness controls
on the external monitor.
Press hotkeys Fn + F5 to change the display.
Refer to Chapter 5,
.
If problems persist, contact your dealer.
If you turn the computer off into Standby Mode while the display is on TV,
the computer will select either the internal LCD or an external computer
CRT as the display device the next time is switched on.