Toshiba X300 User Manual

Page of 245
User’s Manual
viii
Qosmio X300
FCC information
FCC notice "Declaration of Conformity Information"
This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to part 15 of the FCC rules. These limits 
are designed to provide reasonable protection against harmful interference 
in a residential installation. This equipment generates, uses and can radiate 
radio frequency energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful interference to 
radio or television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC conditions
This device complies with part 15 of the FCC Rules. Operation is subject to 
the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including 
interference that may cause undesired operation.
Contact
Address:
TOSHIBA America Information Systems, Inc.
9740 Irvine Boulevard
Irvine, California 92618-1697
Telephone: (949) 583-3000
Only peripherals complying with the FCC class B limits may be attached to 
this equipment. Operation with non-compliant peripherals or peripherals 
not recommended by TOSHIBA is likely to result in interference to radio 
and TV reception. Shielded cables must be used between the external 
devices and the computer’s external monitor port, Universal Serial Bus 
(USB 2.0) ports, i.LINK (IEEE1394) port, HDMI out port and microphone 
jack. Changes or modifications made to this equipment, not expressly 
approved by TOSHIBA or parties authorized by TOSHIBA could void the 
user’s authority to operate the equipment.