Toshiba M200 User Manual

ATS11=90 (DTMF dialing on/off duration=90 ms)

ATX2 (Dial tone detect, but not (U.S.A.) call progress detect)

❑

When used in the Auto Answer mode, the S0 register must be set with a value
of 3 or 4. This ensures:

(a) a person calling your modem will hear a short burst of ringing before  the

modem answers. This confirms that the call has been successfully
switched through the network.

(b) caller identification information (which occurs between the first and

second ring cadences) is not destroyed.

❑

The preferred method of dialing is to use DTMF tones (ATDT...) as this is
faster and more reliable than pulse (decadic) dialing. If for some reason you
must use decadic dialing, your communications program must be set up to
record numbers using the following translation table as this modem does  not
implement the New Zealand “Reverse Dialing” standard.

Number to be dialed: 0 1 2 3 4 5 6 7 8 9

Number to program into computer: 0 9 8 7 6 5 4 3 2 1

Note that where DTMF dialing is used, the numbers should be entered
normally.

❑

The transmit level from this device is set at a fixed level and because of this
there may be circumstances where the performance is less than optimal. Before
reporting such occurrences as faults, please check the line with a standard
Telepermitted telephone, and only report a fault if the phone performance is
impaired.

❑

It is recommended that this equipment be disconnected from the Telecom line
during electrical storms.

❑

When relocating the equipment, always disconnect the Telecom line connec-
tion before the power connection, and reconnect the power first.

❑

This equipment may not be compatible with Telecom Distinctive Alert ca-
dences and services such as Fax Ability.