Toshiba M200 User Manual
8-7
O
PTIONAL
D
EVICES
Memory expansion
2. Place a mat beneath the computer to prevent making a
scratch on the lid when replacing the memory module. Avoid
the mat that generates static electricity.
the mat that generates static electricity.
CAUTIONS: 1. Use only memory modules approved by TOSHIBA.
2. Do not try to install or remove a memory module under
the following conditions. You can damage the
computer and the module. Also, data will be lost.
computer and the module. Also, data will be lost.
a. The computer is turned on.
b. The computer was shut down using the Standby
mode or Hibernation mode.
c. Wake-up on LAN is enabled.
If you install a memory module that is not compatible with the computer, beep will
sound when you turn on the power. If the module is installed in slot A, there will be
a long beep (1 second) followed by two short beeps (0.5 second each). If the
memory module is in slot B, there will be a long beep followed by four short beeps.
If the both memory modules in slot A and slot B are incompatible, there will be a
long beep followed by two short beeps and after a pause (1 second) a long beep
followed by four short beeps. In this case, shut down the power and remove the
incompatible module(s).
sound when you turn on the power. If the module is installed in slot A, there will be
a long beep (1 second) followed by two short beeps (0.5 second each). If the
memory module is in slot B, there will be a long beep followed by four short beeps.
If the both memory modules in slot A and slot B are incompatible, there will be a
long beep followed by two short beeps and after a pause (1 second) a long beep
followed by four short beeps. In this case, shut down the power and remove the
incompatible module(s).
CAUTION: Be sure to install memory module to Slot A. The computer
does not boot when Slot A is vacant.
does not boot when Slot A is vacant.
NOTE: Use a 1-bit, Phillips screwdriver to remove and fasten screws. Use
of an incorrect screwdriver can damage the screw heads.
of an incorrect screwdriver can damage the screw heads.
Installing memory module
Follow the steps below to install a memory module.
1. Save data, shutdown Windows and turn the power off.
2.
Remove the AC adapter cable and other cables from the computer.