Toshiba M200 User Manual
F-3
A
PPENDIX
F
*1 Factory-set default channels
*2 Refer to the sheet
Approved Countries/Regions for use
for the
countries/regions that in which these channels can be used.
When installing Wireless LAN cards, the channel configuration is managed as
follows:
follows:
For wireless clients that operate in a Wireless LAN Infrastructure, the Wireless
LAN card will automatically start operation at the channel identified by the
Wireless LAN Access Point. When roaming between different access points
the station can dynamically switch to another channel if required.
LAN card will automatically start operation at the channel identified by the
Wireless LAN Access Point. When roaming between different access points
the station can dynamically switch to another channel if required.
For Wireless LAN cards installed in wireless clients operating in a peer-to-peer
mode, the card will use the default channel 10.
mode, the card will use the default channel 10.
In a Wireless LAN Access Point, the Wireless LAN card will use the factory-
set default channel (printed in bold), unless the LAN Administrator selected a
different channel when configuring the Wireless LAN Access Point device.
set default channel (printed in bold), unless the LAN Administrator selected a
different channel when configuring the Wireless LAN Access Point device.
Appendix F