Texas Instruments 2000 User Manual

Hard disk failure

Reboot.  If that doesn’t work,

run the DIAG program to check the
hard disk drive, then contact your
Texas Instruments dealer.

Hard disk read 

The hard disk is defective - Reboot.

failure If 

that doesn’t work, run the DIAG

program to check the hard disk,
then contact your Texas
Instruments dealer.

Invalid 

Configuraition 

information 

Display adaptor is incorrrectly
configured, or
Incorrect number of floppy
drives - Check the settings on the
Set Up and Hardware Installation
screens (see Chapter 4).

Keyboard clock/data 

line failure 

keyboard cable connection is
defective - Make sure the keyboard
cable is connected properly.

Keyboard stuck key 

One or more keys are jammed - Try

failure 

pressing the key again.  Run the
DIAG program to check the
keboard keys.

No boot device 

available 

the floppy itself is defective -
Reboot  If that doesn’t work , replace
the floppy.  If the hard disk is faulty,
run the DIAG program, then
contact your Texas Insruments
dealer.

No boot sector on 

hard disk 

formatted - Format the hard disk.
Remember that this will erase all
contents of the hard disk.

Not a boot diskette.  

The floppy in the optional Floppy
Drive Unit is not formatted as a
bootable floppy - Replace the floppy
with a bootable floppy, then reboot.

G-2 B10S Messages