Advantech MIC-3368 User Manual
MIC-3368 Series User Manual -- Page 7
The jumper settings are schematically depicted in this manual as follows:
You may find a pair of needle-nose pliers useful for setting the jumpers.
If you have any doubts about the best hardware configuration for your application,
contact your local distributor or sales representative before you make any changes.
If you have any doubts about the best hardware configuration for your application,
contact your local distributor or sales representative before you make any changes.
1.4.3 Clear CMOS (JP1)
This jumper is used to erase CMOS data and reset system BIOS information. Follow
the procedures below to clear the CMOS.
1. Turn off the system.
2. Close jumper JP2 (2-3) for about 3 seconds.
3. Close jumper JP2 (1-2).
4. Turn on the system. The BIOS is reset to its default setting.
the procedures below to clear the CMOS.
1. Turn off the system.
2. Close jumper JP2 (2-3) for about 3 seconds.
3. Close jumper JP2 (1-2).
4. Turn on the system. The BIOS is reset to its default setting.
Table 1-2: Clear CMOS
CMOS JP1
Clear
Normal (default)
1.5 Connectors
On-board connectors link to external devices such as hard disk drives, keyboards, or
floppy drives, etc. Table 1-3 lists the function of each connector and Figure 1-2 and
Figure 1-3 illustrate each connector location. Chapter 2 gives instructions for
connecting external devices to your card.
floppy drives, etc. Table 1-3 lists the function of each connector and Figure 1-2 and
Figure 1-3 illustrate each connector location. Chapter 2 gives instructions for
connecting external devices to your card.
Table 1-3 MIC-3368 connector descriptions
Number Function
CN1 Secondary IDE (CF)
CN2 Primary IDE
CN4 SODIMM Socket
CN5 Ethernet RJ-45 Connector