Fellowes 120CC User Manual

Paper shredder

Edition 11/00

1.598.999.100

7

If the equipment does not work properly, please
check the following points first:

– Is the plug inserted ?
– Is the switch turned on ?
– Is waste container pushed in properly ?
– Is waste container full ?

Empty container

– Is there a paper jam in the shredder ?
   See Malfunctions
– Is the motor overheated ?

Switch machine off and allow motor to
cool down for approximately 15–20 min.

If none of the above applies and the equipment still
does not run, please contact the appropriate
customer service department.

• Press rocker switch to center position

(2) to stop the cutting system.

• Press and hold down rocker switch in

pos. (3) to reverse the cutting system
and back out jammed material
(paper is pushed out)

Caution!

Do not press rocker switch alternately
forwards/backwards in pos. (1 and 3)

• Remove excess paper.

• Return switch to pos. (1) and continue

shredding in smaller quantities so as
not to jam the machine further.

– Paper shredder switches off automati-

cally. Press rocker switch to center (2)
position.
• Check whether cut material container is

properly pushed into bottom frame.

• Return switch to "on" position (1) and

continue shredding.

– Paper shredder switches off automati-

cally.
• Press rocker switch to center (2)

position.

• Empty cut material container or

exchange cut material bag.

• Return switch to "on" position (1) and

continue shredding.

(Cross cut unit only)

– When tearing capacity drops or the noise

increases:
• Spray special cutting block oil onto

cutting system.

• Run cutting system forward (1) and

backward (3) several times without
feeding paper.

• Continue shredding.