Fellowes 480 User Manual

Edition 01/03

7

Paper shredder

If  the equipment does not work properly,
please check the following points first:

–

Is the plug inserted?

–

Is the switch turned on?

–

Is the cabinet door closed?

–

Is waste receptacle full?

   Empty waste bag.

–

Is there a paper jam in the shredder?

–

Is the motor overheated?

   Switch machine off and allow motor to

cool down for approximately 15–20 min.

If none of the above applies and the equipment stil
does not run, please contact our customer service
department.

Red LED lights

• Press and hold down rocker switch in

pos. 2 to reverse the cutting system
and back out jammed material
(paper is pushed out)

Caution!

Do not 

attempt to force the jammed

material through the machine by
alternating the cutting system between
forward and reverse

• Remove excess paper

• Return switch to pos. 1 and continue

shredding in smaller quantities so as
not to jam the machine further

Note:

The 480-2HS 

will not run 

forward again

unless the jammed material has been
completely removed from the throat

Red LED lights
Paper shredder switches off automati-
cally.

• Tap rocker switch pos. 2

➪

Rocker switch resets to zero
position

• Allow shredder to cool down for

approximately 15-20 minutes.

• Return switch to "on" position (1)

and continue shredding.

Red LED lights
Paper shredder switches off automati-
cally.

• Tap rocker switch pos. 2

➪

Rocker switch resets to zero
position

• Make sure cabinet door is properly

closed and/or empty waste bag.

• Return switch to "on" position (1) and

continue shredding.

(Cross cut unit only)

– When shredding capacity drops or the

noise increases
• Apply oil over full width of cutting

cylinders through the paper entry
(Fellowes Powershred Lubricant
# 35250).
CAUTION: Do not use flammable
synthetic oil, petroleum-based products,
or aerosol lubricants of any kind.

• Run cutting system forward and

backward several times without feeding
paper

• Continue shredding