Avaya Wireless AP-3 User Manual

Avaya Wireless AP-3 User’s Guide                                                                                 7-5

3. Make sure your PC terminal program (such as HyperTerminal) is 

active and configured to the following values: 

— Com Port: (COM1, COM2, etc. depending on your computer); 

— Baud rate: 9600; Data bits: 8; Stop bits: 1; Flow Control: None; 

Parity: None;

— Line Feeds with Carriage Returns 

(In HyperTerminal select: 
File -> Properties -> Settings -> ASCII Setup -> Send Line 
Ends with Line Feeds)

1. Double-check the physical network connections. Use a 

known-good unit to make sure the network connection is present. 
Once you have the AP IP address, you can use the “Ping” 
command over Ethernet to test the IP Address. If the AP responds 
to the Ping, then the Ethernet Interface is working properly.

2. By default, the Access Point will attempt to automatically detect the 

Ethernet settings. However, if you are having problems with the 
Ethernet link, manually configure the Access Point’s Ethernet 
settings. For example, if your switch operates at 100 Mbits/sec/Full 
Duplex, manually configure the Access Point to use these settings 
(see 

). If you cannot access the unit over Ethernet, then 

use the CLI interface over the serial port to configure the Ethernet 
port (see 

 and 

).

3. Perform network infrastructure troubleshooting (check switches, 

routers, etc.).