ArtDio IPS 1000 User Manual

                                                                       

      IPS 1000 Series VoIP Gateway

 

 

18

digits are accepted by phoneset only, you need a mapping between characters and digits. You can find 

them at section 14.4 Mapping table of characters used in PPPoE. 

Example user name：83721@hinet.net，Password：123ab，The procedure is below 

 

1.  Connect the phone to IPS   

 

2.  When CPU/ACT is light, pick up the phone 

and press 

 

3. ##0000 

；You will hear 3 short tones. 

4. 0938333732314068696*465742*46*46574# ；Set user name：83721@hinet.net 

5. 103132336162# 

；Set password is 123ab   

6. 981# 

；Save and restart. 

 

SIP-RG>enable 

SIP-RG#configure 

Enter configuration commands, one per line.    End with CNTL/Z 

SIP-RG(config)#pppoe username 83721@hinet.net 

SIP-RG(config)#pppoe password 123ab 

SIP-RG(config)#exit 

SIP-RG#restart 

This command resets the system.    System will restart operation code agent. 

Reset system, [Y]es or [N]o? Yes 

 

You can configure the user name and password by using WEB interface. Follow the steps to finish 

configuration. 

 

Step 1: Using a traditional phone set to configure the web management password and phone number   

You will need to use a web browser to perform the PPPoE settings through the IPS    unit’s web based 

management interface. To enter the web based management interface you must have a previously 

configured password. Follow the next procedure to setup your password and phone number.   

 

1.  Connect the IPS unit to a suitable Power source. 

2.  Connect a traditional phone set to the “Phone” connector located on the rear panel. 

3.  When the CPU/ACT light is on, pick up the phone. You should hear the dialing tone. 

4.  ##0000     

 

; you should hear three short tones. 

5. 15123 

 

 

; “123” is the web management password. 

6.  010#   

            

; “0” is to enable “manual” IP mode.