Carrier Access Axxius 800 User Manual
Axxius 800 - Release 2.2
16-5
V.35/.54 Card
Card Configuration
Card Configuration
The V.35/54 card can be configured, using the Command Line Interface (CLI).
CLI Commands
The following commands are used to configure the V.35 cards. For detailed
information on these commands, see Chapter 5, CLI Commands.
information on these commands, see Chapter 5, CLI Commands.
l
connect
Creates two-way connections between channels.
Creates two-way connections between channels.
l
disconnect
Removes a connection created by the connect command.
Removes a connection created by the connect command.
l
set (v35)
Setup of channels of a V.35 card (clock, clear to send, data, equipment, line,
receive clock invert, speed, transmit clock invert).
Setup of channels of a V.35 card (clock, clear to send, data, equipment, line,
receive clock invert, speed, transmit clock invert).
l
set (v54)
Set the V.54 loopback test parameters.
Set the V.54 loopback test parameters.
l
show (v54)
Displays the current settings for V.54 (CTS, timing, Rx clock inversion, Tx
clock inversion, data inversion, data speed, data rate, Rx LB, Rx Addr, test
address, Tx Prep count, Rx Prep count, test pattern, ignore ACK, loopback)
Displays the current settings for V.54 (CTS, timing, Rx clock inversion, Tx
clock inversion, data inversion, data speed, data rate, Rx LB, Rx Addr, test
address, Tx Prep count, Rx Prep count, test pattern, ignore ACK, loopback)
l
status (v54)
Displays the current near-end line status of the specified V.54 (DCD, CTS,
DSR, RTS, DTR, BERT).
Displays the current near-end line status of the specified V.54 (DCD, CTS,
DSR, RTS, DTR, BERT).