D-Link DI-701 User Manual
25
Getting Started (Telnet)
1. Power up the DI-701. Wait 30-90 seconds for it to boot up.
2. In Windows 98 start Telnet by clicking StartàRun, type “telnet 192.168.0.1 333”
and press enter. If the local port of the DI-701 is set to something other than
“192.168.0.1” (the factory default), then simply use that IP address instead.
“192.168.0.1” (the factory default), then simply use that IP address instead.
The following information will appear:
IP Sharing for Cable Modem/ADSL Modem/Ethernet
BIOS Version: 1.00 (1999/10/06)
©Copyrights 1999, all rights reserved.
SRAM Test .......... O
WAN NIC Test ........ O MAC Address: 00 E8 80 C8 20 93
LAN NIC Test ........ O MAC Address: 00 E8 80 C8 00 12
Internet SOAR is ready
System starts up
Welcome to SOAR 1.01
Administrator password:
1. No password is required the first time you log in. Press <ENTER> to enter
Configure mode. The screen prompts you for the following command.
command>
2. Type the SET command to configure your DI-701. Press <ENTER> if you agree
with the default value, enter a new value and press <ENTER> if you do not, or
press <ESC> to escape without saving. The SET command will list all
configurable parameters in sequence. For detailed descriptions of each parameter,
read the “DI-701 Setup Software” section which uses analogous parameters.
press <ESC> to escape without saving. The SET command will list all
configurable parameters in sequence. For detailed descriptions of each parameter,
read the “DI-701 Setup Software” section which uses analogous parameters.
3. Refer to the “Terminal Commands” section for a detailed description of terminal
commands.