Bradley Smoker 1734-AENT User Manual
Publication 1734-UM011C-EN-P - December 2006
2-2 Install the Adapter
Mount the Adapter on a DIN
Rail Before Installing
Modules
Rail Before Installing
Modules
Use the following procedure to mount the adapter on a new system
before you install any I/O modules.
before you install any I/O modules.
1. Position the adapter vertically above the DIN rail.
2. Press down firmly to install the adapter on the DIN rail, noting
that the locking mechanism locks the adapter to the DIN rail.
3. Set the network address thumbwheel switches to the desired
value (see Set the Network Address section in this manual).
4. Slide the safety end cap up to remove it.
This exposes the backplane and power interconnections.
WARNING
If you connect or disconnect the Ethernet cable with
power applied to this module or any device on the
network, an electrical arc can occur. This could
cause an explosion in hazardous location
installations.
power applied to this module or any device on the
network, an electrical arc can occur. This could
cause an explosion in hazardous location
installations.
Be sure that power is removed or the area is
nonhazardous before proceeding.
nonhazardous before proceeding.
ATTENTION
Do not discard the adapter’s end cap. Use this end
cap to cover the exposed interconnections on the
last mounting base on the DIN rail. Failure to do
so could result in equipment damage or injury
from electric shock.
cap to cover the exposed interconnections on the
last mounting base on the DIN rail. Failure to do
so could result in equipment damage or injury
from electric shock.
43520