Avocent CCM User Manual
Chapter 2: Installation and Configuration 7
Figure 2.4 shows the back panel of a CCM4850 appliance.
Figure 2.4: CCM4850 Appliance Back Panel
The back panel contains:
•
•
The AC line cord connector.
•
Outflow openings for the two internal fans.
•
A DB-9 DEBUG PORT connector. This port should be used only on the advice and with the
guidance of Technical Support.
guidance of Technical Support.
Installing the CCM Appliance
WARNING: This unit is not user serviceable. To avoid electrical shock, do not attempt to open the unit or operate
with the cover off. Do not attempt to make any repairs. See Appendix F on page 113 for information.
with the cover off. Do not attempt to make any repairs. See Appendix F on page 113 for information.
WARNING: The power outlet should be near the equipment and easily accessible.
To install the CCM appliance hardware:
1. Place the unit where you can connect cables between the serial devices and the CCM serial
ports, and where you can connect a LAN interface cable between the Ethernet hub or switch
and the CCM LAN connector.
and the CCM LAN connector.
2. Connect devices to the CCM serial ports; see Device Cabling on page 95 for cable information.
Connect each serial device to its appropriate power source, following the device’s documentation.
Table 2.1: CCM4850 Appliance LAN LED Values
SPEED LED
LINK/TRAFFIC LED
Description
Off
Off
No link
Off
On
Link at 10 Mbps
Green
On
Link at 100 Mbps
Orange
On
Link at 1000 Mbps
Off
Flashing
Traffic at 10 Mbps
Green
Flashing
Traffic at 100 Mbps
Orange
Flashing
Traffic at 1000 Mbps