Avocent MPX1000 User Manual
30 MPX1000 Extender Installer/User Guide
NOTE: Radio signals propagate outward from the antenna in a disk-like perpendicular manner. A vertical
antenna results in horizontal signal propagation. For this reason, best performance is obtained when the
transmitter and receiver antennas are similarly oriented and aligned on the same horizontal or vertical plane.
antenna results in horizontal signal propagation. For this reason, best performance is obtained when the
transmitter and receiver antennas are similarly oriented and aligned on the same horizontal or vertical plane.
NOTE: With your MPX1000 unit you have received two snap-on ferrites. If you are using the analog audio (RCA
Jacks) these ferrites should be applied to each end of the cables. Apply the ferrites approximately one inch from
the cable ends. One ferrite goes around both cables.
Jacks) these ferrites should be applied to each end of the cables. Apply the ferrites approximately one inch from
the cable ends. One ferrite goes around both cables.
Figure 3.4: Connection Status Page
Final Adjustments
Presentation of audio and video media should now be active at each display device, as if they were
each individually attached to the source device. Inspect each display for signs of hesitation, color
shift, audio loss, or other anomalies. Refer to Fine Tuning Parameters on page 33 for
additional information.
each individually attached to the source device. Inspect each display for signs of hesitation, color
shift, audio loss, or other anomalies. Refer to Fine Tuning Parameters on page 33 for
additional information.