3com 710026 User Manual
Installing the Software in NetWare
21
Installing the NIC Driver for NetWare
Use one of two procedures for installing the NIC software, depending on
whether NetWare is already running on the server or if you are performing an
initial installation of the NetWare 5.1 operating system:
whether NetWare is already running on the server or if you are performing an
initial installation of the NetWare 5.1 operating system:
■
If NetWare is already running on the server, you can edit the
AUTOEXEC.NCF and STARTUP.NCF files to load files and configure the NIC
driver. For the procedure, see "Installing the Driver: NetWare Already
Installed" on page 21.
AUTOEXEC.NCF and STARTUP.NCF files to load files and configure the NIC
driver. For the procedure, see "Installing the Driver: NetWare Already
Installed" on page 21.
■
If you are installing the NIC software as part of an initial installation of
NetWare 5.1, edit the STARTUP.NCF file and configure the NIC driver during
the normal NetWare 5.1 installation process. This version of the
operating system does not allow you to allocate the actual number
of receive buffers required by the NIC until installation is complete.
Install the driver software using the procedure described in
"Installing the Driver: Initial Installation of NetWare 5.1" on page 24.
NetWare 5.1, edit the STARTUP.NCF file and configure the NIC driver during
the normal NetWare 5.1 installation process. This version of the
operating system does not allow you to allocate the actual number
of receive buffers required by the NIC until installation is complete.
Install the driver software using the procedure described in
"Installing the Driver: Initial Installation of NetWare 5.1" on page 24.
Installing the Driver: NetWare Already Installed
This section provides basic guidelines for installing the NIC driver on a server
already running the NetWare operating system. This procedure works for
NetWare 4.2 and 5.1.
already running the NetWare operating system. This procedure works for
NetWare 4.2 and 5.1.
1 Insert the 3Com Gigabit EtherLink Server CD into the appropriate
CD-ROM drive and mount the CD on the server.
2 Copy the 3c986.LAN and the 3c986.LDI files into the \system directory.
The NetWare NIC drivers are located in the NetWare directory on the CD.
3 Edit the STARTUP.NCF file. Set the packet receive buffers
parameters for the number of NICs installed in the system.
To ensure optimum performance, add at least 1024 additional packet
receive buffers for each NIC installed in your system.
receive buffers for each NIC installed in your system.
NOTE: If you are installing NetWare 5.1 for the first time on a server, you
install the NIC driver during the OS installation procedure. You then install
the NetWare 5.1 support pack after you have successfully installed
NetWare 5.1 on the server.
install the NIC driver during the OS installation procedure. You then install
the NetWare 5.1 support pack after you have successfully installed
NetWare 5.1 on the server.
To get the latest support pack files, go to the Novell support website at
http://support.novell.com.
http://support.novell.com.
Using the table above as a guide, select and download the latest support
pack or patch file(s) for the operating system running on your server.
pack or patch file(s) for the operating system running on your server.