Siemens 2000592-001 User Manual

Continued 

 

The ANCB jumper settings for J5 are factory set and dependent upon the 
product the ANCB will be used in. 

Advance Network Gateway 
Ethernet (ANG-EN) 

Pins 3&4 are shorted, switch in 25-
ohm position. 10Base2 connector is 
not normally used (not connected) 

Advance Network Gateway 
DataNET (ANG-DN) 

Pins 1&2 are shorted, switch in 50-
ohm position. 10Base2 connector is 
used as an end point for crossover 
cable. 

Advance Plus Analyzer 

Pins 1& 2 are shorted, switch in 50-
ohm position. 10Base2 connector is 
used as an end point for crossover 
cable. 

Maxum Analyzers with ANCB/DN 
Installed 

Pins 3&4 are shorted, switch in 25-
ohm position. 10Base2 connector is 
not normally used (not connected) 

 

See ANCB LEDs Description and Operation, page 49. 

•  Troubleshooting